Setting Up A Client Computer - Gestetner DSc224 Network Manual

Windows 95/98/Me Configuration

Setting Up a Client Computer

This section describes the procedures for setting up a client on a network that
uses Windows 2000/XP, Windows NT Server or Windows NT Workstation as a
1
print server.
When using a Windows 2000/XP or Windows NT print server, select a shared
printer on Windows 2000/XP or Windows NT.
Limitation
❒ When using a print server connected to the machine with SmartNetMonitor
for Client, you cannot use Recovery Printing and Parallel Printing.
❒ When using Windows XP as a print server, the client computer cannot receive
notification of print job completion.
Note
❒ This section assumes that the client has already been configured to communi-
cate with a Windows 2000/XP or Windows NT print server. Do not begin the
following procedure until the client has been set up and configured correctly.
A A A A
Install the printer driver as a local printer.
Reference
For more information about installing the printer driver, see the Printer
Reference 1.
Note
❒ Any port can be selected during the installation, however, LPT1 is recom-
mended.
B B B B
Click [Start], point to [Settings], and then click [Printers].
20
Windows 2000/XP or
Windows NT Print Server
Windows 95/98/Me