Confirming The Connection - Gestetner DSc224 Network Manual

Confirming the Connection

A A A A
Make sure the LED of the IEEE
802.11b card is lit.
❖ ❖ ❖ ❖ When using in Infrastracture Mode
1.
If the IEEE 802.11b card is work-
ing, it is lit in orange. If the IEEE
802.11b (wireless LAN) is not select-
ed, it does not light, even if the print-
er power is on.
2.
If it is connected properly to a net-
work, the LED is green in infrastruc-
ture mode. When the LED is blinking,
the machine is searching for devices.
❖ ❖ ❖ ❖ When using in Ad hoc Mode/802.11
Ad hoc Mode
1.
If the IEEE 802.11b card is work-
ing, it is lit in orange.
2.
If it is connected properly to a net-
work, the LED is in green in ad hoc
mode or 802.11 ad hoc mode. When
the LED is blinking, the machine is
searching for devices. The LED will
light after a few seconds.
B B B B
Use a Web Browser to check the
printer is connected properly. See
p.88 "Configuring the Network
I n t e r f a c e B o a r d w it h a W e b
Browser".
C C C C
Print the configuration page to
verify settings.
For information about how to print
the configuration page, see the
Printer Reference 2.
Infrastructure Mode
1
2
You can check the Wireless LAN Sig-
nal using the machine's control panel.
ZGDH600J
A A A A
Press the { { { { User Tools/Counter/In-
quiry} } } } key.
B B B B
Press [System Settings].
C C C C
Press [Interface Settings].
D D D D
Press [IEEE 802.11b].
E E E E
Press [Wireless LAN Signal].
F F F F
Make sure that settings are com-
plete, and then press [Exit].
1
2
ZGDH600J
Using the IEEE 802.11b (Wireless LAN)
7
101