When Using The Nib Setup Tool; When Using Ipp With Smartnetmonitor For Client - Gestetner DSc224 Network Manual

Appendix
Using telnet
A A A A
Connect to the remote printer using telnet.
B B B B
Use the "set" command to make WINS active.
msh> set wins on
C C C C
Specify the IP addresses (primary and secondary) using the following com-
mands.
msh> wins primary Ipaddress
msh> wins secondary Ipaddress
Note
❒ To confirm the current configuration, use the "show" command.
D D D D
Log out from telnet.

When Using the NIB Setup Tool

If the Network Interface Board cannot browse using the TCP/IP protocol, make
sure that the TCP/IP environment is correctly configured in your computer.
7

When Using IPP with SmartNetMonitor for Client

When using IPP with SmartNetMonitor for Client, note the following:
• The network printer can only receive one print job from SmartNetMonitor for
Client at a time. While the network printer is printing a job, another user can-
not access the network printer until it completes the job. In this case, Smart-
NetMonitor for Client tries to access the network printer until the retry
interval expires.
• If SmartNetMonitor for Client cannot access the network printer and times
out, SmartNetMonitor for Client stops sending the print job. In this case, you
should cancel the paused status from the print queue window. SmartNet-
Monitor for Client will resume access to the network printer. You can delete
the print job from the print queue window, but canceling a print job that has
been printed by the network printer might cause the next print job sent from
another user to be incorrectly printed.
• If a print job that is sent from SmartNetMonitor for Client is interrupted and
the network printer cancels the job because something went wrong, launch
the print job again.
• Print jobs sent from another computer do not appear in the print queue win-
dow regardless of the protocol.
• If various users send print jobs using SmartNetMonitor for Client to network
printers, the printing order might not be in the order in which the jobs were sent.
• An IP address cannot be used for the IPP port name because the IP address is
136
used for the SmartNetMonitor for Client port name.