Configuring Protocols; Configuring Tcp/Ip And Ipp For Printing - Gestetner DSc224 Network Manual

Configuring Protocols

Configuring TCP/IP and IPP for Printing

These instructions are for configuring the Network Interface Board and Win-
dows 2000 to use the TCP/IP protocol and IPP.
Configuring the machine
Configure the machine to use the TCP/IP protocol.
• Make sure that the TCP/IP protocol is set to active. (The default is active.)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information about how to make the above settings, see the General
Settings Guide.
If DHCP is used to assign IP addresses, see p.134 "Using DHCP".
To use the IP over 1394, see the General Settings Guide.
Note
❒ After setting the IP address, use the ping command to make sure that it has
been set correctly.
A Click [Start], point to [Programs], point to [Accessories], and then click [Com-
mand Prompt].
B Type the following: (Example IP address is 192.168.15.16)
C:\> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
Configuring a Windows 2000 computer
These steps are for configuring a Windows 2000 computer to use the TCP/IP
protocol.
A A A A
Click [Start] on the taskbar, point to [Settings], and then click [Network and
Dial-up Connections].
B B B B
Double-click [Local Area Connection]. On the [General] tab, click [Properties].
Configuring Protocols
25
2