Gestetner DSc224 Network Manual page 118

Appendix
ROUTE
Use the route command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote PCs using this command.
Note
❒ The maximum number of routing tables are 16.
Commands
route add {host | net} desti-
*1
nation gateway
route delete {host | net}
*1
destination
route get {destination
route active {host | net} des-
*1
tination on/off
route add default gateway
*1
route flush
7
*1
IP address
SLP
Use this command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5/5.1. To use the slp command, you can configure the value of TTL
which can be used by the SLP multi-cast-packet.
Note
❒ The default value of TTL is "1". A search is executed only within a local seg-
ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Setting IEEE 802.11b
Use the wiconfig command to configure the IEEE 802.11b settings.
Limitation
❒ You can make settings when installing the optional 802.11b Interface Kit.
112
Topics of setting
Adds a host/network route to "destination", and a gateway ad-
*1
dress to "gateway" in the table. Host becomes the default setting.
Deletes a host/network route from the table. Host becomes the
default setting.
*1
} Displays only route information corresponding to a specified
destination. When the destination is unspecified, all routing in-
formation is displayed.
You can turn the specified destination on or off. Host becomes
the default setting.
You can set the default gateway address.
Deletes all routing information.