Setting Up; Installation Mode; Interface Board (Optional) - Panasonic PT-RQ13K Operating Instructions Manual

Setting up

Note
f The light output will decrease as much as the power supply voltage is decreased. It is recommended to use with AC 200 V or higher to
prioritize luminance.

Installation mode

The installation modes of the projector are as follows. Set the [PROJECTOR SETUP] menu → [PROJECTION
METHOD] (x page 128) depending on the installation mode.
Mounting on the ceiling and projecting forward
Menu item
[PROJECTION METHOD]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
Portrait setting and projecting from the rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
Note
f In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu in portrait, go to the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] (x page 121) and change the
[OSD ROTATION] setting.

Interface Board (optional)

This projector is equipped with two SLOT NX-specification slots.
There are four SDI input terminals and one DIGITAL LINK input terminal equipped on this projector as the
standard video input terminals. The input for HDMI, DVI-D, and SDI can be added by installing the optional
Interface Board in the slot.
Attention
f Requesting a qualified technician to install or remove the optional Interface Board is recommended. A malfunction may occur due to static
electricity. Consult your dealer.
Chapter 2 Getting Started — Setting up
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Setting value
[FRONT/CEILING]
Setting on a desk/floor and projecting forward
Setting value
[REAR/CEILING]
Portrait setting and projecting forward
Setting value
[REAR/FLOOR]
Menu item
[PROJECTION METHOD]
Menu item
[PROJECTION METHOD]
Menu item
[PROJECTION METHOD]
Setting value
[REAR/FLOOR]
Setting value
[FRONT/FLOOR]
Setting value
[FRONT/FLOOR]
ENGLISH - 35