How To Remove The Interface Board - Panasonic PT-RQ13K Operating Instructions Manual

Chapter 6 Appendix — Installing the Interface Board (optional)
Attention
f The removed slot cover is required when the unnecessary Interface Board is removed. Store it so it can be attached in the future.

How to remove the Interface Board

1) Remove the Interface Board. (Fig. 1)
f Remove the four screws fixing the Interface Board by rotating counterclockwise with a Phillips screwdriver.
The removed screws are used to fix the slot cover.
f Hold the handle of the Interface Board and remove it slowly.
2) Attach the slot cover.
f Attach the stored slot cover, and tighten and fix with the four screws removed in Step 1).
f To replace with other Interface Board, attach the Interface Board following the procedure in "How to install
the Interface Board" (x page 222).
Attention
f Always attach the slot cover on the blank slot.
f Store the removed Interface Board inside an antistatic bag.
Handle
Fig. 1
ENGLISH - 223