[Projector Setup] Menu; [Projector Id]; [Projection Method]; [Operation Setting] - Panasonic PT-RQ13K Operating Instructions Manual

[PROJECTOR SETUP] menu

On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-
menu.
Refer to "Navigating through the menu" (x page 76) for the operation of the menu screen.

[PROJECTOR ID]

The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press as to select [PROJECTOR ID].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ALL]
[1] - [64]
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to "Setting ID number of the remote control" (x page 74) for how to set the ID number on the remote control.

[PROJECTION METHOD]

Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
1) Press as to select [PROJECTION METHOD].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[FRONT/FLOOR]
[FRONT/CEILING]
[REAR/FLOOR]
[REAR/CEILING]

[OPERATION SETTING]

Set the operation method of the projector.
The settings are reflected when "Initial setting (operation setting)" (x page 57) in the [INITIAL SETTING]
screen is already set.
If you change the settings while using the projector, the duration until the luminance of light source decreases by
half may shorten or the luminance may decrease.
Setting [OPERATING MODE]
1) Press as to select [OPERATION SETTING].
2) Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3) Press as to select [OPERATING MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
*1
128 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when controlling projectors without specifying an ID number.
Select this item when specifying an ID number to control individual projector.
When installing the projector on the desk, etc., in front of the screen
When installing the projector in front of the screen using the Ceiling Mount Bracket (optional)
When installing the projector on the desk, etc., behind the screen (with a translucent screen)
When installing the projector behind the screen (with a translucent screen) using the Ceiling Mount
Bracket (optional)
Set this item when high luminance is required. The estimated runtime is approximately 20 000 hours.