Removing An Expansion Card Riser - Dell EMC E39S Series Installation And Service Manual

Table 60. Riser configurations:1A (continued)
Card type
Infiniband HCA FDR (Mellanox)
40G NICs (Intel)
40G NICs (Mellanox)
FC32 HBA (QLogic)
FC32 HBA (Emulex)
25G NICs (Broadcom)
25G NICs (Mellanox)
25G NICs (QLogic)
FC16 HBA (QLogic)
FC16 HBA (Emulex)
10Gb NICs (Broadcom)
10Gb NICs (Intel)
10Gb NICs (Mellanox)
10Gb NICs (QLogic)
10Gb NICs (Solarflare)
FC8 HBA (Emulex)
FC8 HBA (QLogic)
1Gb NICs (Broadcom)
1Gb NICs (Intel)
External RAID (Dell design)
Integrated RAID (Dell design)
rNDC (Broadcom)
rNDC (Intel)
rNDC (Mellanox)
rNDC (QLogic)

Removing an expansion card riser

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Before removing the expansion card riser 2A, remove the expansion card from the riser, if installed.
4. Disconnect any cables connected to the expansion card.
Steps
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
NOTE: While removing the riser 1B, press the tabs and hold the touch point to lift the expansion card riser from the
system board.
Slot priority
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1, 2
1
1, 2
1, 2
1, 2
1, 2
Integrated Slot
Integrated Slot
Integrated Slot
Integrated Slot
Integrated Slot
Safety instructions on page 71.
Before working inside your system
Form factor
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
NONE
NONE
NONE
NONE
NONE
on page 72.
Installing and removing system components 113