Table of Contents
Advertisement
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
NOTE:
It is recommended that you always use an antistatic mat and antistatic strap while working on components inside
the system.
CAUTION:
To ensure proper operation and cooling, all bays in the system and system fans must be always populated
with a component or a blank.
Before working inside your system
Prerequisites
Follow the safety guidelines listed in
Steps
1. Turn off the system, including all attached peripherals.
2. Disconnect the system from the electrical outlet and disconnect the peripherals.
3. If applicable, remove the system from the rack.
For more information, see the Rack Installation Guide at https://www.dell.com/poweredgemanuals.
4. Remove the system cover.
After working inside your system
Prerequisites
Follow the safety guidelines listed in
Steps
1. Reconnect the peripherals and connect the system to the electrical outlet.
2. Turn on the attached peripherals and then turn on the system.
Recommended tools
You need the following tools to perform the removal and installation procedures:
•
Key to the bezel lock
The key is needed only if your system includes a bezel.
•
Phillips #1 screwdriver
•
Phillips #2 screwdriver
•
1/4 inch flat head screwdriver
•
Torx #T30 screwdriver
•
Wrist grounding strap
You need the following tools to assemble the cables for a DC power supply unit.
•
AMP 90871-1 hand-crimping tool or equivalent
•
Tyco Electronics 58433-3 or equivalent
•
Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE:
Use alpha wire part number 3080 or equivalent (65/30 stranding).
72
Installing and removing system components
Safety instructions
on page 71.
Safety instructions
on page 71.
Hide quick links:
Advertisement
Table of Contents
