Removing The 2.5 Inch Drive Rear Backplane - Dell EMC E39S Series Installation And Service Manual

Figure 84. Installing the backplane
Next steps
1. Connect all the cables to the backplane.
2. Install all the drives.
3. Install the backplane cover.
4. Install the air shroud.
5. Follow the procedure listed in

Removing the 2.5 inch drive rear backplane

Prerequisites
CAUTION: To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION: You must note the number of each drive and temporarily label them before removal so that you can replace
them in the same locations.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove all the drives from the rear drive cage.
4. Disconnect all the cables from the backplane.
5. Remove the rear drive cage.
Steps
1. Using Phillips #2 screwdriver, remove the screws that secure the drive backplane to the rear drive cage.
2. Disengage the backplane from the hooks on the rear drive cage, and remove it from the rear drive cage.
After working inside your system
Safety instructions on page 71.
Before working inside your system
on page 72.
on page 72.
Installing and removing system components 135