Removing The Right Control Panel - Dell EMC E39S Series Installation And Service Manual

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. For ease of removal of the right control panel,
Steps
1. Lift the cable latch and disconnect the control panel cable from the connector on the system board.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route
the cables properly when you replace them to prevent the cables from being pinched or crimped.
2. Using a Phillips #1 screwdriver, remove the screws that secure the cable cover to the system.
Figure 117. Removing the cable cover
3. Using a Phillips #1 screwdriver, remove the screw that secures the control panel to the system.
Figure 118. Removing right control panel
4. Holding by the sides, remove the right control panel away from the system.
5. Holding the control panel by its sides, remove the control panel away from the system.
Next steps
Install the right control panel.
Safety instructions on page 71.
Before working inside your system
remove the cooling fan
on page 72.
#8 to access the cable latch.
Installing and removing system components 165