Figure 85. Removing the 2.5 inch drive rear backplane
Figure 86. 2 X 2.5 rear drive backplane
1. power connector
3. SAS cable connector
Next steps
Install the 2.5 inch drive rear
Installing the 2.5 inch drive rear backplane
Prerequisites
Follow the safety guidelines listed in
Steps
1. Use the hooks on the rear drive cage as guides to align the drive backplane.
2. Lower the backplane into the system until it is firmly seated.
3. Using Phillips #2 screwdriver, replace the screws to secure the backplane to the rear drive cage.
136
Installing and removing system components
backplane.
Safety instructions
on page 71.
2. backplane signal connector
4. NVMe cable connector