Installing A Drive Blank; Removing A Drive Carrier - Dell EMC E39S Series Installation And Service Manual

Figure 24. Removing a drive blank
Next steps
1. Install a drive or a drive blank.

Installing a drive blank

Prerequisites
1. Follow the safety guidelines listed in
2. If installed, remove the front bezel.
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 25. Installing a drive blank
Next steps
If removed, install the front bezel.

Removing a drive carrier

Prerequisites
1. Follow the safety guidelines listed in
2. If applicable, remove the front
3. Using the management software, prepare the drive for removal.
Safety instructions on page 71.
Safety instructions on page 71.
bezel.
Installing and removing system components 77