Figure 57. Installing the expansion riser 2A
Figure 58. Installing the expansion riser 2B
Next steps
1. Follow the procedure listed in
2. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If applicable,
remove the air
4. If applicable, disconnect the cables from the expansion card.
5. When removing a card from riser 2 or 3, ensure that the PCIe card holder latch is closed.
After working inside your system
Safety instructions
Before working inside your system
shroud.
on page 72.
on page 71.
on page 72.
Installing and removing system components
117