Installing The Microsd Card - Dell EMC E39S Series Installation And Service Manual

Figure 72. Removing the MicroSD card
Next steps
1. Follow the procedure listed in
2. Install a MicroSD card.

Installing the MicroSD card

Prerequisites
Follow the safety guidelines listed in
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked
on the cards during removal.
Steps
1. Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the
NOTE: The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
After working inside your system
Safety instructions on page 71.
on page 72.
System board jumpers and connectors
Installing and removing system components
section.
127