Table of Contents
Advertisement
3. Follow the procedure listed in
4. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5. Enter the correct time and date in the System Setup Time and Date fields.
6. Exit the System Setup.
USB module
Removing the USB module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the backplane
4.
Remove the air
shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route these
cables properly when you replace them to prevent them from being pinched or crimped.
NOTE:
The procedure to remove the USB 3.0 and USB 2.0 modules is similar.
Steps
1. Disconnect the USB cable from the USB connector on the system board. For more information, see the System board jumpers and
connecters section.
2. Using Phillips #1 screwdriver, remove the screws on the USB module.
3. Slide the module out of the system until it is free of the USB module slot on the front panel.
Figure 100. Removing the USB module
Next steps
Install the USB
module.
After working inside your system
Safety instructions
Before working inside your system
cover.
on page 72.
on page 71.
on page 72.
Installing and removing system components
147
Hide quick links:
Advertisement
Table of Contents
