Installing The M.2 Ssd Module - Dell EMC E39S Series Installation And Service Manual

2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the BOSS card.
NOTE: Removing the BOSS card is similar to the procedure for removing an expansion card riser.
Steps
1. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
2. Pull the M.2 SSD module away from the BOSS card.
Figure 68. Removing the M.2 SSD module
a. module connector (2)
b. screws (2)
c. module (2)
Next steps
Install the M.2 SSD module.

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
Steps
1. Align the M.2 SSD module connectors with the connectors on the BOSS card.
2. Push the M.2 SSD module until the module is seated firmly on the BOSS card.
3. Secure the M.2 SSD module on the BOSS card with the retention straps and screws.
Before working inside your system
Safety instructions on page 71.
on page 72.
Installing and removing system components 123