Error Messages - Furuno FA-100 Operator's Manual

2.7

Error Messages

The FA-100 displays the following error messages to alert you to invalid data,
etc..
Message
BATTERY ERROR!
BACKUP ERROR
ENTER MMSI
NO SEL. RENEW AGAIN
CAN'T DISPLAY OVER LAT85°
CAN'T DISPLAY INVALID DATA
NO MMSI
SYNCHRONISM CAN'T TAKEN
NO MESSAGE!
SEND FAILED!
UNSUCCESSFUL!
NO MESSAGE
OUT OF RANGE!: DRAUGHT:0-25.5 Invalid draught entered in SET SHIP DATA.
OUT OF RANGE!: YEAR
OUT OF RANGE!: MONTH:1-12
OUT OF RANGE!: DAY:1-29/30/31
OUT OF RANGE!: HOUR:0-23
OUT OF RANGE!: MINUTE:0-59
OUT OF RANGE!: CREW:0-8191
OUT OF RANGE!: CPA:0-6.00
OUT OF RANGE!: TCPA:0-60
OUT OF RANGE!: CH-A:IT
DOESN'T EXIST
OUT OF RANGE!: CH-A:IT
DOESN'T EXIST
OUT OF RANGE!: ZONE:1-8
ERROR REGIST
OUT OF RANGE!: ROT CYCLE:1-10 Invalid ROT entered in SET I/O menu.
2 MAINTENANCE, TROUBLESHOOTING
Error messages
Voltage of backup battery is getting low.
ROM contents erased because voltage of backup
battery is too low.
Your MMSI was not found when turning on the power.
No data found for target selected (target data,
dangerous ship).
Own ship's latitude is higher than 85°.
Invalid own ship position.
MMSI not entered when SEND MSG is set for
ADDRESS-CAST.
Slot synchronization not yet performed when you
attempted to send a message.
No TX message when you attempted to send a
message.
Transmission failed.
Message sent did not reach specified station. (Not
receiving ACK.)
No TX or RX message.
Invalid year entered in SET DESTINATION.
Invalid month entered in SET DESTINATION.
Invalid day entered in SET DESTINATION.
Invalid hour entered in SET DESTINATION.
Invalid minute entered in SET DESTINATION.
Invalid crew no. entered in SET CREW&TYPE.
Invalid CPA range entered.
Invalid TCPA entered.
Invalid CH-NO. A entered on the CHANNEL EDIT
sub-menu.
Invalid CH-NO. A entered on the CHANNEL EDIT
sub-menu.
Invalid ZONE entered on the CHANNEL EDIT
sub-menu.
Duplicate data in overlapping sea areas.
Meaning
35