Adjusting Display Brilliance And Contrast - Furuno FA-100 Operator's Manual

The FA-100 starts receiving data from AIS-equipped ships as soon as it is
turned on, and the ships' location on the plotter display is shown with the AIS
symbol. (To learn more about the plotter display, see paragraph 1.7.) With
connection of a radar or ECDIS, the AIS target symbols may be overlaid on the
radar or ECDIS.
Note 1: If no navigation sensor is installed or a sensor such as a gyrocompass
has failed, the AIS automatically transmits "not available" data.
Note 2: The reporting intervals are as follows
Ship's navigation status
Moored
0-14 kt speed
0-14 kt speed with course change
14-23 kt speed
14-23 kt speed with course change
Speed higher than 23 kt
Speed higher than 23 kt with course change
1.3

Adjusting Display Brilliance and Contrast

1. Press the [CLR/ALM]+[SFT/ +/-] keys together to show the dialog box
below.
2. Use the [▲] or [▼] key to adjust brilliance; [◄] or [►] key to adjust contrast.
3. Press the [ENT] key to close the dialog box.
Note: If you turn off the equipment with minimum contrast, the startup screen is
displayed in high contrast at the next power-on. However, the plotter
display, which appears after the startup screen, will be shown in
minimum contrast. Therefore, adjust the contrast as described above.
Ship's navigation status and reporting interval
BRILLIANCE
G
CONTRAST
J
ESC: [ENT]
Dialog box for adjustment of brilliance and contrast
1 OPERATION
Reporting interval
3 min
10 s
3+1/3 s
6 s
2 s
2 s
2 s
F
K
3