Error Message; Ais Priority Setting Window - Furuno FA-100 Installation Manual

12. Set L/L position, COG and SOG data priority with the numeric keys according to
sensors connected.
COG: Course over ground
SOG: Speed over ground
13. Press the [ENT] key to return to the I/O PRIORITY window.
Note: If you have entered 8, 9 or the same value for more than one item at step
12, the following error message appears. In this case, press the [ENT]
key and set the priority correctly.
[ERROR]
CAN NOT INPUT
14. Set the priority for HDG and ROT similar to how you did for "L/L COG SOG".
The priority of heading data entered from the AD-10 IN port is the lowest.
15. To set the priority of AIS, press the [4] key to choose AIS.
16. With RESPONSE selected, press the [SFT] key to select PC, NONE, LAN, EX1
or LR as appropriate.
Set an output port for response from other party after you transmit messages or
interrogation from the PC, ECDIS, LR, or LAN.
NONE : No output for response
PC : Output to PC I/O port
LR : Output to LR or ECDIS/RADAR port
EX1 : Output to EXTRA1 port
The PC I/O port provides RS-422 and RS-232C terminals. For example, to
connect a PC for pilot, connect it to the RS-422 terminal and set 34.8 Kbps for bit
rate on the PC I/O option in the I/O SPEED window.
17. Press the [NEXT] key to select EX1, LR, PC or LAN.
18. Press the [SFT] key to select ENBL (enable) or DSBL (disable) as appropriate.
This setting is for communication between FA-100 and each external equipment.
"DSBL" disables communication with selected item.
19. Press the [ENT] key and then [MENU] key to return to the SET I/O PORT
sub-menu.
28
SAME VALUE !
ESC: [ENT]

ERROR message

[AIS]
RESPONSE:PC
- - - - - - - - - - - - - - - - - - - -
EX1 : ENBL
LR : ENBL
PC : ENBL
LAN: ENBL
DEFAULT: [CLR]

AIS PRIORITY setting window

[ERROR]
OUT OF RANGE !
PRIORITY: 1-7
ESC: [ENT]
+ -
+ -
+ -
+ -
+ -