Enabling/Disabling The Buzzer - Furuno FA-100 Operator's Manual

Note: To check or edit settings on previous page, press the [NEXT] key
18. Press the [ENT] key.
19. YES is selected; press the [ENT] key to register settings. (If the password
entry screen is displayed, MMSI is set to DEFAULT. This cannot be
changed.)
20. Press the [MENU] key several times to close the menu.
Note: If you enter invalid data an appropriate error message appears. Press
the [ENT] key and then reenter data.
1.12

Enabling/Disabling the Buzzer

The buzzer that sounds against CPA or TCPA violation, message reception and
system trouble may be enabled or disabled as below. Note that this buzzer is
not related to a radar or ECDIS alarm.
1. Press the [MENU] key to open the menu.
2. Press the [6] key to open the SYSTEM SETTINGS menu.
3. Press the [5] key to choose SET BUZZER.
4. ALARM is selected; press the [SFT/ +/-] key to choose ON or OFF as
appropriate. This alarm is given to system trouble.
5. Press the [NEXT] key to choose CPA/TCPA or MSG ALM, and then press
the [SFT/ +/-] key to choose ON or OFF as appropriate.
6. Press the [ENT] key to register settings.
7. Press the [MENU] key several times to close the menu.
LEFT-BOTTOM
Description of RIGHT-TOP, LEFT-BOTTOM, ZONE
while pressing the [SFT +/-] key.
[SET BUZZER]
ALARM
CPA/TCPA : ON
MSG ALM : ON
SET BUZZER menu
20-200 nm
RIGHT-TOP
ZONE
1-8 nm
+ -
: ON
+ -
+ -
1 OPERATION
25