Chapter 2 Installation; Overview; Installing The Bbg-1022-2Fs; Installing Using Bbg-1000-Tray Optional Mounting Tray - Cobalt Digital Inc BBG-1022-2FS Product Manual

Overview

Installing the BBG-1022-2FS

Installing Using BBG-1000-TRAY Optional Mounting Tray

BBG1022-2FS-OM (V1.3)
This chapter contains the following information:
Installing the BBG-1022-2FS (p. 2-1)
•
Rear Panel Connections (p. 2-2)
•
GPIO, Serial (COMM), and Analog Audio Connections (p. 2-5)
•
Note: • Where BBG-1022-2FS is to be installed on a mounting plate (or regular table
or desk surface) without optional frame Mounting Tray BBG-1000-TRAY,
affix four adhesive-backed rubber feet (supplied) to the bottom of
BBG-1022-2FS in locations marked with stamped "x". If feet are not affixed,
chassis bottom cooling vents will be obscured.
• Where BBG-1022-2FS is to be installed with optional frame Mounting Tray
BBG-1000-TRAY, do not affix adhesive-backed feet.
BBG-1000-TRAY
securely attached to a 1 RU tray that fits into a standard EIA 19" rack
mounting location. Install BBG-1022-2FS unit into tray as described and
shown here.
If installing BBG-1022-2FS using optional frame Mounting Tray
1.
BBG-1000-TRAY, install BBG-1022-2FS in tray as shown in Figure 2-1.
Connect the input and output cables as shown in Figure 2-3.
2.
BBG-1022-2FS PRODUCT MANUAL
Installation
Chapter 2
allows up to three BBG-1022-2FS to be mounted and
Chapter 2
2-1