Cobalt Digital Inc BBG-1022-2FS Product Manual page 87

Setup/Operating Instructions
Table 3-2 BBG-1022-2FS Function Submenu List — continued
• Device IP Receive Setup/Status
• Device IP Transmit Setup/Status
BBG1022-2FS-OM (V1.3)
BBG-1022-2FS Function Menu List and Descriptions
IP Port Setup sub-tab provides IP setup for device UDP IP
communications.
Shows device receiving IP address/status and sets port as follows:
• Card Active IP: Shows the device IP address. (IP address is set
using Admin tab Networking settings; see Admin (Log Status/
Firmware Update) on page 3-68).
• Card Port: Sets device IP receive port.
• Insertion / Rx Status: Shows device IP receive/Rx insertion status.
- Stopped (with yellow indicator) means no data is being received.
- Green indicator means data is being received and inserted. Data
rate is also shown.
Provides setup for destination IP address and shows device transmit
status as follows:
• Extraction / Tx Status: Shows device extraction from stream to Tx
status.
- Stopped (with yellow indicator) means no data is being sent.
- Green indicator means data is being extracted and sent. Data rate
is also shown.
• Destination IP/Port: Allows setting destination IP address and port.
• Extraction Mode: Sets the IP data sent to consist of only payload,
or send as formatted packets.
BBG-1022-2FS PRODUCT MANUAL
3-57