Wings Insertion - Cobalt Digital Inc BBG-1022-2FS Product Manual

3
Table 3-2 BBG-1022-2FS Function Submenu List — continued

Wings Insertion

Note:
Wings tab has identical independent controls for both Path 1 and Path 2 using the Path 1 / Path 2 sub-tabs. Therefore,
only the Path 1 controls are shown here. Set controls for other path using the respective sub-tab.
• Wings Source Control
• Wings Insertion Enable Control
• Wings Width Control
3-52
BBG-1022-2FS Function Menu List and Descriptions
Provides wings insertion/width controls and displays
insertion status.
Selects the SDI input video port to serve as the wings source.
Note: • SDI inputs selected must be used with Rear I/O Module
correspondingly equipped with intended input ports.
• Other wings input choices sourced from Path 1 and Path 2
program video outputs also are available using this drop-down.
These selections are not typically used for normal use. A white
paper describing these use cases may be developed in the
future that explains the use of special looping alternate-path
inputs. In brief, these alternate inputs are useful for providing
two identical video paths with a delay offset provided by the
second path.
Enables or disables wings insertion into the output video.
Note: For conditions where wings is not intended to be inserted, make
certain this control is set to Disabled.
Allows symmetrical L/R wings insertion width, from none to widths
extending into active image area if desired.
(0 to 300 pixel range; null = 0)
BBG-1022-2FS PRODUCT MANUAL BBG1022-2FS-OM (V1.3)