Table of Contents
Advertisement
Overview
Setting I/O Switches for AES I/O (1-4) Ports
9083-ENC-OM (V4.4)
Installation and Setup
Chapter 2
This chapter contains the following information:
•
Setting I/O Switches for AES I/O (1-4) Ports (p. 2-1)
•
Installing the 9083 Into a Frame Slot (p. 2-2)
•
Installing a Rear I/O Module (p. 2-5)
•
Setting Up 9083 Network Remote Control (p. 2-12)
Note:
This procedure is applicable only if any of the four AES I/O (1-4) ports on the
9083 are to be used as outputs (the switches are set to input mode by factory
default). The 9083 is equipped with a four-section red DIP switch that sets
AES pairs 1 thru 4 as either inputs or outputs. The factory default position is
the input position for each pair.
• If all of the AES I/O (1-4) ports are to be used as inputs (or not used at all),
omit this procedure.
• If any of the AES I/O (1-4) ports are to be used as outputs, set the switches
as described in this procedure.
Note switch S11 thru S14 settings for
Figure 2-1. For port to be used as an output, set switch to down position as
shown in Figure 2-1.
Note:
Regardless of S11 thru S14 settings for
OUT (1-4) are still available on cards equipped with a Rear I/O Module having
dedicated
AES OUT
9083 (WITH DOLBY ENCODING OPTION) PRODUCT MANUAL
AES I/O 1
AES I/O 1
BNC connectors.
Chapter 2
thru
mode shown in
AES I/O 4
thru
, outputs AES
AES I/O 4
2-1
Advertisement
Table of Contents
Troubleshooting
