Cobalt Digital Inc BBG-1022-2FS Product Manual page 113

Setup/Operating Instructions
.
Electronic device or assembly is susceptible
to damage from an ESD event. Handle only
using appropriate ESD prevention practices.
From underside of card, locate
1
the SD card receptacle
With SD card labeling facing up
2
(as shown), gently push the
card into the receptacle until it
clicks and locks into place
Press and hold MMC BOOT button
1
2 Power-up card and continue holding
button for 3 seconds, then release
button
BBG1022-2FS-OM (V1.3)
Figure 3-10 SD Card Installation
(See Figure 3-11.) With card powered-down, locate the
2.
button on the card. Proceed as shown in picture.
COM LED
Figure 3-11 MMC Boot Button
With button now released, the card will begin reprogramming:
3.
COM
•
When reprogram is complete,
•
again (entire process takes about 1-1/2 minute).
Remove power from the card (remove card from slot or power-down
4.
BBG-1000 Series unit).
BBG-1022-2FS PRODUCT MANUAL
FRONT OF CARD
LED illuminates and remains illuminated.
Troubleshooting
MMC BOOT
LED turns off, on, and then off
COM
3-83