Reticules - Cobalt Digital Inc BBG-1022-2FS Product Manual

3
Table 3-2 BBG-1022-2FS Function Submenu List — continued

Reticules

Note:
Reticules tab has identical independent controls for both Path 1 and Path 2 using the Path 1 / Path 2 sub-tabs.
Therefore, only the Path 1 controls are shown here. Set controls for other path using the respective sub-tab.
Typical Reticule/Overlay Marker Insertions
The BBG-1022-2FS allows any combination of the reticule/overlay markers to be applied to the output video. Sizing and other
characteristics for each type of marker can be set as described below.
Note: • Overlay markers using this function are for setup only. When enabled, these markers are embedded in the output
video and will appear in the image. Use this function only on preview video and not on-air video. Make certain any
overlay tools are turned off when no longer needed.
• Multiple overlay markers described below can be simultaneously enabled as desired.
• Insertion Master Enable/Disable
• Safe Action Area (SAA) Controls
3-42
BBG-1022-2FS Function Menu List and Descriptions
Allows Safe Action and/or Safe Title overlays and other
static markers to be added to the output video image.
Safe Action Area (SAA) Reticule
Safe Title Area (STA) Reticule
Graticule
Center Cross
Provides independent master enable/disable for SDI and CVBS outputs.
• When enabled, any combination of reticules or other markers described
below can be inserted.
• When disabled, insertion of all reticules or other markers is disabled.
• SAA provides enable/disable of safe action area graticule insertion.
• SAA Height and SAA Width control height and width of insertion (from
0% to 100% of 4:3 outputted image area).
Note: Reticule Size control is locked to Custom, with safe action area size
control as described above.
BBG-1022-2FS PRODUCT MANUAL BBG1022-2FS-OM (V1.3)