Wiring Specifications - Honeywell Silent Knight SK318PT Installation And Operation Manual

Terminal Label
Ring
Tip
Ring
Tip
Ring
Tip
Ring
Tip
P7 Data
Network

3.5 Wiring Specifications

Induced noise (transfer of electrical energy from one wire to another) can interfere with telephone communication or cause false alarms.
To avoid induced noise, follow these guidelines:
• Isolate input wiring from high current output and power wiring. Do not pull one multi-conductor cable for the entire panel. Instead,
separate the wiring as follows:
• Do not pull wires from different groups through the same conduit. If you must run them together, do so for as short a distance as
possible or use shielded cable. Connect the shield to earth ground at the panel. You must route high and low voltages separately.
• Route the wiring around the inside perimeter of the cabinet. It should not cross the circuit board where it could induce noise into the
sensitive microelectronics or pick up unwanted RF noise from the high speed circuits. See Figure 3.1 for an example.
• High frequency noise, such as that produced by the inductive reactance of a speaker or bell, can also be reduced by running the wire
through ferrite shield beads or by wrapping it around a ferrite toroid.
18
Description
Phone Line 1 Telco Ring
Phone Line 1 Telco Tip
Phone Line 1 Premises Ring
Phone Line 1 Premises Tip
Phone Line 2 Telco Ring
Phone Line 2 Telco Tip
Phone Line 2 Premises Ring
Phone Line 2 Premises Tip
Used for SK-NIC
Table 3.1 Terminal Descriptions and Electrical Specification
High voltage
SLC loops
POTS reporting input/output Phone line circuits, TELCO
Notification circuits
SBUS
Relay circuits
Rating
Voltage
N/A
N/A
24 VDC 21 mA
AC power Terminals
In/Out Terminals
NAC 1-6
SBUS1 In/Out Terminals, Cellular
communication
Trouble, Relay 1, Relay 2 Terminals
6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017
Earth Ground
Faults
Current
0
0
0