Table of Contents
Advertisement
Pressing Select Key 2 will start a playback of the recorded message.
Press
Select Key 2
to record
Message to
this slot
11.8.2 Recording Messages 1-15 Using the Microphone
Messages can be recorded into the EVS system by using the on board microphone.
Follow these steps to use the microphone to record your message:
1.
Enter programming mode at main control panel.
2.
Select option 8 Voice Options.
3.
Select 1 for VCM Maintenance.
4.
Select option 2 Local Recording.
NOTE: The VCM will light the green Select Key LED for message slots that are occupied. If a message is already stored in the desired slot,
then you must erase the message first. (see Section 11.8.3)
5.
Select the amplifier and circuit for the audio to play through during programming. A user would generally pick the audio circuit that
is in closest proximity to them.
6.
Press EVS Message Key 1 to enter the message slot selection mode. Then, press the Select Key 1-15 that corresponds to the
message slot that you wish to record to. The associated Select Key red LED will begin flashing, indicating that the message slot is
ready for recording.
7.
Press the push-to-talk (PTT) button on the microphone and speak your message.
8.
Release the PTT button on the microphone to save your message. The Select Key green LED for this location will turn on.
9.
To playback the recorded message, press the Select Key 1-15 that was just recorded to.
10. If you are not satisfied with the recorded message, erase it (see Section 11.8.3) and then repeat steps 1 through 7.
Recording with Microphone Example:
User wants to record a message to message slot 5 via the microphone.
Upon entering the Local Recording mode via the keypad menu, the VCM will light the Select Key green LEDs for 1-15 for each occu-
pied message slot.
If a message already exists in message slot 5, it must first be erased. Press EVS Message key 8, then press Select Key 5, (see Section
11.8.3). When the message has been erased Select Key 5's green LED will turn off.
To record a message, press EVS Message Key 1, press Select Key 5 (this will use message slot 5 for the recording). Select Key 5's red
LED will begin flashing.
Press the push-to-talk button on the microphone and speak your message. Release the PTT button to save your message. Select Key 5's
red LED stays on until processing is completed. Select Key 5's green LED comes on after the recording is completed.
6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017
Figure 11.6 Aux Audio Input Example
Press EVS
Message Key
1 to enter message
slot selection mode
Press EVS
Message Key 3
to start and stop
recording from
the Aux Audio
Input
159
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
