I-View ANYCAM DM-2MIPA 04 Series Manual page 59

2. Enter the Static IP, Subnet mask, Default router, and Primary DNS provided by your ISP Subnet
mask: This is used to determine if the destination is in the same subnet The default value is
"255.255.255.0".
3. Configure the NIC settings, including the IPv4 (IPv6) Address, IPv4(IPv6) Subnet Mask and
IPv4(IPv6) Default Gateway. IPV6 protocol version No. is 6 will available later.
DNS1: The primary domain name server that translates hostnames into IP addresses
DNS2: Secondary domain name server that backups the Primary DNS
1. If the DHCP server is available, you can check to automatically obtain an IP address and
other network settings from that server.
2. The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 9676.
3. The Multicast sends a stream to the multicast group address and allows multiple clients to
acquire the stream at the same time by requesting a copy from the multicast group address.
4. Before utilizing this function, you have to enable the Multicast function of your router and
configure the gateway of the network.
5. If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the Preferred DNS Server and Alternate DNS server.
6. The router must support the route advertisement function if you select Route Advertisement
as the IPv6 mode.
 PPPoE: If you have no router but only a modem, you can use Point-to-Point Protocol over
Ethernet (PPPoE) function. Click this button to enable the PPPoE function. Select this option to
configure your Network Camera to make it accessible from anywhere as long as there is an
Internet connection
Note that to utilize this feature, it requires an account provided by your ISP.
 Port Settings: If there is a router and you want to access the speed dome through Wide Area
Network (WAN), you need to forward the 3 ports for the IP Camera. Click this button to modify
the HTTP (Default is 80), RTSP (Default is 554) or Device Port number (Default is 5050), Https
streaming port (Default is 443 and click Save to change the setting.
 RTSP Port: Use domain name to access and login device need mapping RTSP, default port is 554.
RTSP Validation: Choose RTSP verification mode, Http-Base64, Http-Digest selectable.
After clicking to check and enable the corresponding RTSP verification mode, when playing RTSP
59