I-View ANYCAM DM-2MIPA 04 Series Manual page 58

7. Check " FullJPEG " icon will snapshot the best quality.
8. Face Quality Threshold: Setup the value threshold of face detection, less the setting value will
ignore the image.
9. Capture Quality: Setup the value threshold of snapshot image quality, less the setting value will
get poor image quality, but file size will be less.
10. Interval: Entry the interval period and the IP camera snapshot the image base on the setting
period.
11. Target Percent: Setup the minimum and maximum percentage ration (target size/ image area) of
effective motion detection targets. You can find out the blue mark after setup the target percent.
Once the targets ration is smaller than the setting value, the system will ignore the target which
motion trigger.
12. Specify the notify method (Such as Trigger alarm output, move PTZ camera position, notify via
email) when an event occur.
13. Click Save to change the setting.
 Network Setting: Click this button to setup the Network parameters.
 IP Setting: Click this button to modify the current Internet protocol with IPv4 or IPv6, IP address,
enable/disable DHCP and DNS IP address.
Get IP address automatically: Select this option to obtain an available dynamic IP address
assigned by the DHCP server each time the camera is connected to the LAN.
Use Static IP address: Select this option to manually assign a static IP address to the Network
Camera.
1. You can make use of IP Search tools on the software CD to easily set up the Network Camera
on LAN. Please refer to Quick user guide for details.
58