I-View ANYCAM DM-2MIPA 04 Series Manual page 22

 Fix the camera on the Ceiling & Wall
1) Paste the Mount hole sticker on the position that you want to install.
2) According to your needs, create 6mm (0.2") holes at the T1/T2template positions. Then insert the
screw anchors into the holes. If you want to feed wiring from the hole on the top of the back case,
create a circular opening (bottom conduit hole) in the mounting surface.
3) Press the Ethernet cable into the routing path at the bottom of the camera so that the cable will not
get in the way when the metal mounting plate is attached, and then arrange these cables through the
hole of ceiling or wall.
4) Align the back case and the lens base, and then fasten the TP4 screws into the inserted anchors.
5) Adjust the focusing position by rotating and panning the camera base. Note that the back case side
conduit hole is the point where the camera will not rotate past.
6) Fix the cover to finish the camera installation.
22