Icom IC-M506GE Instruction Manual page 47

Manual Reply:
q Select "POSITION REPLY" in the DSC CALLS menu.
➪ ➪
MENU DSC
(Push [MENU]) (Select icon)
• If no Position Request call has
been received, the "Position
Reply" item will not be dis-
played.
• Push [BACK] to return to the
previous screen.
• Push [EXIT] to return to the
normal operating mode.
w Select a desired Position
Request call to reply to, us-
ing dial or [Y]/[Z], then push
[ENT].
e The Position Reply call
confirmation screen is dis-
played.
Push [CALL] to transmit the
acknowledgement call.
Position Reply
(Rotate dial, then push [ENT].)
r While transmitting the reply call, the screen shown below
is displayed, and then the transceiver returns to the normal
operating mode.
When no GPS receiver is connected, and both position and
time have been manually programmed, the screen shown
below is displayed. Edit your latitude and longitude position
and UTC time as follows:
➥ Push [CHG], then edit your latitude and longitude position
and UTC time.
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or dial to set it.
• To move the cursor, rotate dial or select either arrow, "←" or
"→," then push [ENT] or dial.
• Select N (North latitude) or S (South latitude) when the cursor
is on the 'N' or 'S' position.
• Select W (West longitude) or E (East longitude) when the cur-
sor is on the 'W' or 'E' position.
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
41