Atis Code Entry - Icom IC-M506GE Instruction Manual

3
PREPARATION

■ ATIS code entry

The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be entered at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been en-
tered, this procedure is not necessary.
q Push [MENU].
w Rotate dial or push [Ω]/[≈] to select the "RADIO SET" icon
and then push the softkey below the icon.
• The RADIO SETTINGS menu is displayed.
e Rotate dial or push [Y]/[Z] to select "CHAN Group," and
then push [ENT].
r Rotate dial or push [Y]/[Z] to select "ATIS," and then push
[ENT].
t Push [BACK] twice.
y Rotate dial or push [Ω]/[≈] to select the "ATIS" icon and
then push the softkey below the icon.
• ATIS code programming screen appears.
• Push [CLEAR] to cancel the programming, and go to the normal
operating mode. In this case, the ATIS function is disabled. To
program the ATIS code, repeat the steps q and y.
8
(For Dutch and German version transceivers)
u Enter your ATIS code in the following manner:
• Select a desired number using [∫]/[√]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, rotate dial or select either arrow, "←" or "→,"
then push [ENT] or dial.
i Repeat step u to enter all 10 digits.
o After entering the 10 digit code, "FINISH" is automatically
selected, and then push [ENT] or Dial to set it.
!0 The "ATIS CONFIRMATION" screen is displayed.
!1 Enter your ATIS code again for confirmation.
• Enter in the same manner as steps u through o.
!2 When your ATIS code entry is successfully completed, the
screen as shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The entered ATIS code can be checked in the MENU screen.
(p. 85)