Icom IC-M506GE Instruction Manual page 42

7
DSC OPERATION
D Transmitting a Test call
Testing on the exclusive DSC distress and safety calling chan-
nels should be avoided as much as possible. When testing on
a distress/safety channel is unavoidable, you should indicate
that these are test transmissions.
Normally the test call would require no further communica-
tions between the two stations involved.
q Select "TEST CALL" in the DSC CALLS menu.
➪
MENU DSC
(Push [MENU]) (Select icon)
w Select a desired pre-programmed individual address, or
"Manual Input," then push dial or [ENT].
• The ID code for the Individual call can be set first. (p. 18)
• When "Manual Input" is selected, set the 9 digit MMSI ID code for
the individual you wish to call.
• Push [EXIT] to return to the normal operating mode.
• Push [BACK] to return to the previous screen.
36
➪ Test Call
(Rotate dial, then push [ENT].)
About Manual Inputting:
Enter a desired address ID in the following way:
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or dial to set it.
• To move the cursor, rotate dial or select either arrow, "←" or "→,"
then push [ENT] or dial.
• The first digit is specified as '0' for a Group ID. If a 9 digit Group ID
is entered, an error beep sounds when pushing [ENT] or dial.
• The first two digits are '0' for any Coast station ID.
e A confirmation screen is displayed.
• Confirm the call contents.