Figure 37. Installing the M.2 SSD module
a. module connector (2)
b. screws (2)
c. modules (2)
Next steps
1.
Install the BOSS
card.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2.
Install the air
shroud.
3. Follow the procedure listed in
Network Daughter Card
Removing the Network Daughter Card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the PCIe mezzanine
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION:
To prevent damage to the NDC, you must hold the card only by its edges.
2. Lift the card from the system board.
After working inside your system
Safety instructions
on page 45.
Before working inside your system
card.
on page 46.
on page 45.
Installing and removing system components
75