Figure 82. Installing the M.2 SSD module
Next steps
1. Install the BOSS card.
NOTE:
Installing the BOSS card is similar to
2.
Install the air
shroud.
3. Follow the procedure listed in
Network daughter card riser
Removing the NDC riser
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Disconnect the cables connected to the Network Daughter Card (NDC) riser.
Steps
1. Slide the riser retention bracket to unlock the NDC riser.
2. Hold the NDC riser by its edges, and pull the NDC riser until the card edge connector disengages from the connector on the
system board.
3. Lift the NDC riser from the system.
98
Installing and removing system components
installing the expansion card
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 30.
on page 29.
on page 30.