Figure 41. Installing the BOSS card
Next steps
1.
Install the M.2 BOSS
module.
2. Follow the procedure listed in the
Network Daughter Card
Removing the Network Daughter Card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the mezzanine
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION:
To prevent damage to the NDC, you must hold the card only by its edges.
2. Lift the card from the system board.
After working inside your
Safety instructions
Before working inside your system
card.
sled.
on page 46.
on page 46.
Installing and removing system components
81