Table of Contents
Advertisement
Figure 34. Installing the heat sink onto the processor
Next steps
1.
Install the processor and heat sink
2.
Install the air
shroud.
3. Follow the procedure listed in
Installing a processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat sink is
necessary to maintain proper thermal conditions.
WARNING:
The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat
sink to cool before removing it.
Follow the safety guidelines listed in
Steps
1. Align the pin 1 indicator of the heat sink to the system board and then place the processor and heat sink module (PHM) on the
processor socket.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE:
Ensure that the PHM is held parallel to the system board to prevent damaging the components.
2. Push the blue retention clips inward to allow the heat sink to drop into place.
72
Installing and removing system components
module.
After working inside your system
Safety instructions
on page 45.
on page 46.
Advertisement
Table of Contents
