Figure 21. Installing the drive cage.
Next steps
1.
Install the drive
backplane.
2.
Install the
drives.
3. Follow the procedure listed in
Drive backplane
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and the drive backplane, you must remove the drives from the system
before removing the drive backplane.
CAUTION:
Note the number of each drive and temporarily label them before removal so that you can replace them at the
same locations.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the
drives.
Steps
1. Using the Phillips #2 screwdriver, loosen the retention screws securing the drive backplane to the drive cage.
2. Lift the drive backplane by its edges only until the guide pin on the drive cage disengages from the guide on the drive backplane.
After working inside your system
Safety instructions
on page 45.
Before working inside your system
on page 46.
on page 45.
Installing and removing system components
59