Table of Contents
Advertisement
Figure 52. Removing the internal MicroSD card
Next steps
Install the internal micro SD
Installing an internal micro SD card
Prerequisites
Follow the safety guidelines listed in
NOTE:
To use an micro SD card with your system, ensure that the Internal SD Card Port is enabled in
Steps
1. Locate the micro SD card connector on the internal dual SD module. Orient the micro SD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
NOTE:
Temporarily label each SD card with its corresponding slot before removal.
88
Installing and removing system components
card.
Safety instructions
on page 45.
System
Setup.
Advertisement
Table of Contents
