Hard Drives; Ports And Connectors Specifications; Usb Ports; Internal Dual Sd Module - Dell E02B005 Installation And Service Manual

Table of Contents

Advertisement

Hard drives

The Dell EMC PowerEdge FC640 system supports up to two 2.5-inch SAS or SATA hard drives or PCIe SSDs. The hard drives or SSDs
are supplied in a hot-swappable drive carriers that fit in the drive bays and these drives connect to the system board through the drive
backplane.

Ports and connectors specifications

USB ports

The Dell EMC PowerEdge FC640 system supports:
One USB 3.0-compliant port on the front of the system
One micro USB/iDRAC direct USB 2.0-compliant port on the front of the system
One USB 3.0-compliant internal port
NOTE:
The micro USB 2.0-compliant port on the front of the system can only be used as an iDRAC Direct or a
management port.

Internal Dual SD Module

The Dell EMC PowerEdge FC640 system supports two internal micro SD cards dedicated for the hypervisor. This card offers the following
features:
Dual card operation — maintains a mirrored configuration by using micro SD cards in both slots and provides redundancy.
Single card operation — single card operation is supported, but without redundancy.
NOTE:
One IDSDM card slot is dedicated for redundancy. It is recommended to use Dell branded micro SD cards
associated with the IDSDM/micro SD vFlash configured systems.

Micro SD vFlash connector

The Dell EMC PowerEdge FC640 system supports one dedicated micro SD card for vFlash support.

Video specifications

Table 9. Video specifications
Features
Video type
Video memory

Environmental specifications

NOTE:
For additional information about environmental certifications, please refer to the Product Environmental
Datasheet located with the Manuals & Documents on
Table 10. Temperature specifications
Temperature
Storage
Continuous operation (for altitude less than 950 m or 3117
ft)
Maximum temperature gradient (operating and storage)
Specifications
Matrox G200 graphics controller integrated with iDRAC
4 GB DDR4 shared with iDRAC application memory
www.dell.com/poweredgemanuals
Specifications
–40°C to 65°C (–40°F to 149°F)
10°C to 35°C (50°F to 95°F) with no direct sunlight on the equipment.
20°C/h (68°F/h)
Technical specifications
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

E02bEmc poweredge fc640

Table of Contents