Figure 38. Installing the M.2 SSD module
a. module connector (2)
b. screws (2)
c. modules (2)
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Network Daughter Card
Removing the Network Daughter Card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the mezzanine
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the Network Daughter Card (NDC) to the system
board.
CAUTION:
To prevent damage to the NDC, you must hold the card only by its edges.
2. Lift the card from the system board.
46
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
card.
system.
system.