Figure 2-18 Lc/Pc Fiber Connector; Table 2-26 Wiring Of The Fiber - Raisecom Gazelle S1020i-LI User Manual

Raisecom
Gazelle S1020i-LI (A) User Manual


Appearance
Figure 2-18 shows the appearance of the LC/PC fiber connector.

Figure 2-18 LC/PC fiber connector

When connecting or removing the LC/PC fiber connector, align the connector with the optical
interface, and do not rotate the fiber. Operate the fiber as below:


Wiring
Table 2-26 lists the wiring of the fiber.

Table 2-26 Wiring of the fiber

relationship
Single-fiber
connection
Dual-fiber
Usage
other devices.
Choose the connector type and jumper cable length reasonably based on the on-
site requirements.
Choose a connector suitable for the optical interface. Otherwise, it may increase
additional loss of fiber links, reduce transmission quality of services, or even
damage the connector and optical interface.
To connect the fiber, align the header of the fiber with the optical interface and insert the
fiber into the interface gently.
To remove the fiber, press down the spring clip, and push the fiber header inwards, and
then pull the fiber out.
Wiring Local optical interface
Optical interface
Optical interface Tx
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Local Remote
connector connector
Direction of
optical signals
<->
->
2 Hardware structure
Type Standard
2-mm MMF
Peer optical interface
Optical interface
Optical interface Rx
30