Figure 4-6 Inserting The Optical Module - Raisecom Gazelle S1020i-LI User Manual

Raisecom
Gazelle S1020i-LI (A) User Manual
When the Gazelle S1020i-LI is not used, put a dustproof cover on the optical
interface to prevent dust and dirt from entering it, ensuring that the Gazelle S1020i-LI
works normally.
There is invisible laser inside the Gazelle S1020i-LI, which may cause eye injury.
Therefore, do not look directly into the optical interface, header of the optical
connector, or breakage of the fiber.
Inserting optical module
Insert the SFP optical module into the optical interface on the Gazelle S1020i-LI.

Figure 4-6 Inserting the optical module

Connect LC/PC fiber
Step 1 Remove the plastic dustproof cover from the optical module and keep it for later use.
Step 2 To insert the fiber, align the fiber header with the optical interface and insert the fiber into the
optical interface gently.
Figure 4-7 Inserting the fiber
Step 3 To remove the fiber, push the fiber connector inward slightly, press the spring clip downward,
and then pull out the fiber.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
4 Hardware installation
40