Button; Interface Properties; 1000Base-X Sfp Optical Interface; Table 2-5 Power And Management Interfaces - Raisecom Gazelle S1020i-LI User Manual

Raisecom
Gazelle S1020i-LI (A) User Manual
Management and auxiliary interfaces
Table 2-5 lists the power and management interfaces of the Gazelle S1020i-LI.

Table 2-5 Power and management interfaces

Interface type
Power interface
Console interface RJ45 interface, used to debug and configure the device by using the
ALM alarm
interface
DI interface
Ground terminal

2.2.2 Button

Table 2-6 lists the button of the Gazelle S1020i-LI.

Table 2-6 Button of the Gazelle S1020i-LI

RST (reset button)

2.3 Interface properties

2.3.1 1000BASE-X SFP optical interface

Table 2-7 lists parameters of the 1000BASE-X SFP optical interface.

Table 2-7 Parameters of the 1000BASE-X SFP optical interface

Connector type
Optical interface properties
Coding scheme
Duplex mode
Standard
Using the 2-PIN Phoenix connector interface, and inputting 12/24
VDC power
Console cable to connect the Console interface on the device to the
PC
3-PIN Phoenix connector interface, used to output alarms
3-PIN Phoenix connector interface, used to input digital signals
Round pressed ground terminal, used to connect the ground cable
Type


Parameter
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Interface card
Shortly press it for less than 3s to restart the device.
Press it over 3s to restore factory settings.
Description
LC/PC
Depending on the selected SFP optical module
8B/10B
Full duplex
IEEE 802.3-compliant
2 Hardware structure
15