Leds; Table 2-13 Parameters Of The Di Interface; Table 2-14 Leds - Raisecom Gazelle S1020i-LI User Manual

Raisecom
Gazelle S1020i-LI (A) User Manual

Table 2-13 Parameters of the DI interface

Connector type
Input voltage range
High level
Low level
Maximum input current

2.4 LEDs

Table 2-14 lists LEDs on the Gazelle S1020i-LI, which are located at the line side on the front
panel. Lights are guided to the front panel through light pipes.

Table 2-14 LEDs

DC power status
LED
System status
LED
Alarm output
LED
Network
management
LED
Ethernet
interface status
LED
Parameter
5.08 mm × 3-pin Phoenix connector
-30 to +30 VDC
13–30 VDC
-30 to +1 VDC
8 mA
LED Print

PWR1

PWR2
SYS
ALM
MGMT
LINK/ACT Green
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Status

Green: the power supply is normal.
Green

Off: the power supply is abnormal or off.

Green: the system is being started or
Green
working improperly.

Blinking green: the system is working
properly.
 Off: the system is being started or
working improperly.
 Red: the system is being started or an
Red
alarm is generated, such as DI input,
temperature threshold crossing,
abnormal interface status, and abnormal
power status.
 Off: the system is started and no alarms
are generated or alarms are cleared in the
system.
 Green: the device is being accessed.
Green
 Off: power supply 1 is abnormal or off.
 Green: the optical/electrical interface is
in Link Up status.
 Blinking green: the optical/electrical
interface is receiving or sending data.

Off: the optical/electrical interface is in
Link Down status.
2 Hardware structure
Description
19