Power Up Your Prestige; Navigating The Smt (System Management Terminal) Interface; Figure 2-3 Initial Screen; Figure 2-4 Password Screen - ZyXEL Communications Prestige 100L User Manual

Prestige 100L IDSL Router
2.4

Power Up Your Prestige

When you power on your Prestige, it performs several internal tests and also does an IDSL line
initialization. After this initialization, your Prestige asks you to press the [Enter] key to continue as shown
on the initial screen.
Initial Screen
Copyright (c) 1994 - 2000 ZyXEL Communications Corp.
ethernet address: 00:a0:c5:01:23:45
Resetting IDSL Firmware.(2) IDSL Firmware Rev : V 09E
...............................
Press ENTER to continue...
Entering Password
The login screen appears after you press the [Enter] key, prompting you to enter the password as shown on
the next screen.
For your first login, enter the default password 1234. As you type the password, the screen displays an (X)
for each character you type.
Please note that if there is no activity longer than 5 minutes after you log in, your Prestige automatically
logs you out and displays a blank screen. If you see a blank screen, press the [Enter] key to bring up the
login screen again.
2.5 Navigating the SMT (System Management Terminal)
Interface
The SMT is the interface that you use to configure your Prestige.
Several operations that you should be familiar with before you attempt to modify the configuration are
listed in the following table.
2-4
Figure 2-3 Initial Screen
Enter Password: XXXX
Figure 2-4 Password Screen
Hardware Installation and Initial Setup