BEC MX-230 M1 User Manual page 77

seconds. After the timeout expires, meaning no data transmission within the defined time,
serial connection will get aborted. Time range from 10 – 180 seconds
 TCP Client:
Remote Host Name / IP: Enter either TCP server's name or IP address.
◼
◼
Port: Default used 782(tcp/udp) for TCP Client. Specify a tcp/udp port other than port 782
if needed.
◼
Empty Serial Buffer When TCP Connection is Established: When TCP link connection
is established, serial buffer will get deleted. Enable to empty the buffer after TCP
connection is up.
◼ Data packet Delimiter: A way to keep packets in tract.
⚫
Inter-character Time Gap: Default time is in 1000ms. After time has reached, serial
data will be transmitted. Time range from 1 – 30000ms.
⚫
Character Delimiter: Default characters are 0x0d0a. Serial data will get transmitted
when seeing the specified character(s), in this case, 0x0d0a. Valid characters "0x" +
Hex code.
◼ TCP Idle Timeout (Seconds): Default time is in 60 seconds. Specify an idle time-out in
seconds. After the timeout expires, meaning no data transmission within the defined time,
serial connection will get aborted. Time range from 10 – 180 seconds.
 Telnet Server:
◼
Port: Default used 782(tcp/udp) for Telnet Server. Specify a tcp/udp port other than port
782 if needed. Port 23 is being reserved, don't use this port.
Note: MX-230 M1 uses port 23 as default port the embedded Telnet server.
BEC MX-230 M1 User Manual
Device Configuration
VPN – OpenVPN (Example)
72